Rancang Bangun Charger Otomatis Cut-Off 12v Untuk Pengisian Aki Pada Tempat Sampah Otomatis

Authors

  • Hawin Miftakhul Rizqi Politeknik Baja Tegal
  • Agung Nugroho Politeknik Baja Tegal
  • Ayu Ningrum P. Politeknik Baja Tegal

Keywords:

Battery, Charger, Cutt- off, Operational Amplifier (Op-Amp), Relay

Abstract

Overcoming the problem of energy availability in areas with limited sunlight with the use of solar panels as a renewable energy source has become a major focus. Discuss the design and application of an automatic cut-off charger on the battery (battery) of an automatic trash can that uses solar panels as a source of battery charging (battery), with this charger design it is hoped that automatic trash cans can get electricity reserves by utilizing this battery charger (battery) when sunlight is absent or less than optimal, this research is descriptive qualitative research and uses data processing with data reduction, literature study and processing with software. Battery charger (battery) automatic cut-off works using Operational Amplifier (Op-Amp) model IC TL071 as a voltage sensor that controls the current input to the transistor when the non-inverting input is greater than the inverting input with a reference of 5, 1 Volt at the input of the inverting integrated circuit IC TL071 then the output of IC TL071 will be directly high approaching the positive line voltage (VCC), thus the transistor gets the Voltage Basis Emitter (VBE) current and provides current to the relay through the emitter leg to the relay coil so that the relay gets voltage and the relay moves from Normally Close (NC) to Normally Open (NO) condition.

References

Alisrobia, G., Asri, H. N., Kautsar, M. A., Utomo, M. S. D.,

Hasanah, M., & Fujiyanti, V. (2022). Analisis Rangkaian Komparator Dengan Variasi Ic Op-Amp Yang Tersedia Pada Circuit Wizard. Circuit: Jurnal Ilmiah Pendidikan Teknik Elektro, 6(2), 116–

125.

Asfan, M. J., Arsana, M., & Pd, S. (2021). Rancang Bangun Baterai Charger Otomotif (Vol. 06).

Basri, I. Y., & Irfan, D. (2018).

Komponen Elektronika.

Cahyono, R. P. (2022). Presentasi Pengenalan Komponen Elektronika “Resistor Da Dioda.” Jurnal Portal Data, 2(4).

Danang, D., & Siswanto, S. (2019). Konsep Pengendali Lampu Penerangan Rumah Dari Jarak Jauh Menggunakan Gelombang Frekuensi. Elkom: Jurnal Elektronika Dan Komputer, 12(2), 34–49.

Hidayati, Q., Yanti, N., & Jamal, N. (2020). Sistem Pembangkit Panel Surya Dengan Solar Tracker Dual Axis. Prosiding Snitt Poltekba, 4, 68–73.

Irvan Darmansyah, A., Sumardiono, A., Alimudin, E., & Rahayu,

M. (2021). Tempat Sampah Otomatis Berbasis Internet Of Things Dengan Penyulangan Hybrid Pv- Grid. Jitel (Jurnal Ilmiah Telekomunikasi, Elektronika, Dan Listrik Tenaga), 1(2), 189–200.

Https://Doi.Org/10.35313/Jit el.V1.I2.2021.189-200

Nasution, M. (2021). Karakteristik Baterai Sebagai Penyimpan Energi Listrik Secara Spesifik. Jet (Journal Of Electrical Technology), 6(1),

35–40.

Oorschot, P. F. Van, & Pustjens, J. W. (2022). Eepower-Resistor- Guide (Eepower.Com). Eetech Media.

Pambudi, P. E. (2019). Aplikasi Pengubah Daya Tegangan Dc Ke Ac Berbasis Trafo Non Ct Dan Transistor Mosfet. Jurnal Teknologi Technoscientia, 97–107.

Pangaribuan, H. S. (2020). Sistem Monitoring Perubahan Tegangan Generator Tenaga Angin Berbasis

Mikrokontroler Atmega32.

Pasaribu, F. I., & Reza, M. (2021). Rancang Bangun Charging Station Berbasis Arduino Menggunakan Solar Cell 50 Wp. Rele (Rekayasa Elektrikal Dan Energi):

Jurnal Teknik Elektro, 3(2), 46–55.

Putri, G. A. A., & Mandenni, N. M. I.

M. (2019). Desain Saklar Otomatis Untuk Kontrol Peralatan Listrik Di Bangunan. Jurnal Ilmiah Merpati (Menara Penelitian Akademika Teknologi Informasi), 7(1).

Reyval, D. (2022). Elektronika Dasar Transistor Dan Cara Kerjanya. Jurnal Portal Data, 2(4).

Rusli, M. (2021). Merancang Penelitian Kualitatif Dasar/Deskriptif Dan Studi Kasus. Al-Ubudiyah: Jurnal Pendidikan Dan Studi Islam, 2(1), 48–60.

Salam, M. A., Aribowo, W., Widyartono, M., & Wardani,

A. L. (2020). Monitoring Dan Kendali Charger Accu Berbasis Node-Red.

Sebayang, E. D., Erwansyah, K., & Elfitriani, E. (2022). Implementasi Teknik Counter Pada Sistem Cut Of Charger Handphone Berbasis Arduino. Jurnal Sistem Komputer Triguna Dharma (Jursik Tgd), 1(3), 95–100.

Siburian, J. (2019). Karakteristik Trafo. Jurnal Teknologi Energi Uda: Jurnal Teknik Elektro, 8(01), 21–28.

Suprianto, D., Firdaus, V. A. H., Agustina, R., & Wibowo, D.

W. (2019). Microcontroler Arduino Untuk Pemula. Penerbit Jasakom-Malang.

Downloads

Published

2025-10-21

How to Cite

Hawin Miftakhul Rizqi, Agung Nugroho, & Ayu Ningrum P. (2025). Rancang Bangun Charger Otomatis Cut-Off 12v Untuk Pengisian Aki Pada Tempat Sampah Otomatis. Informatic and Elektronic Technology Journal, 1(2), 26–35. Retrieved from https://ejournal.pbjt.ac.id/index.php/FOREK/article/view/14